Chris Craft Stinger
(REF# 42617)
US$21,500.00
Reduced
26'5", 1984, 2 x gas 4 stroke 260hp
GRP Construction, Planing underwater profile, 1 berths
|
| Extra Details
| Designer: | Chris Craft |
| Builder: | Chris Craft |
| Fuel capacity: | 1 x 110.0 USG |
| Last survey: | Unknown |
|
|
Mechanical
2 x gas 4 stroke 260hp, Mercruiser Thunderbolt 350ci Chevys (unknown year)
raw-water cooled,
wheel steering,
out drive, Stainless prop(s).
Fuel consumption (approx) Unknown,
Cruising speed 35 knots,
Max speed 45 knots.
Engines and out drives completely rebuilt from crankshaft bearings up in 2007, 12 hour on new engines
|
|
Electrical Systems
12 volt, 2 batteries charged by: engine
|
|
| Dimensions
| LOA: | 26'5" |
| LWL: | 0'0" |
| Beam: | 8'6" |
| Draft Min: | 2'6" |
| Draft Max: | 0'0" |
| Displacement: | 7,600.0lbs |
| Headroom: | 0'0" |
| Storage: | In water |
|
| Construction
GRP Construction with Planing underwater profile, gelcoat finish.
|
| Rig
|
| Sails
|
| Accommodation
1 berths with 1 doubles and 0 singles in 1 cabin(s).
Sink
Manual water system
|
|
| Nav Equipment
Compass, Speed, Depth sounder, VHF, Stereo |
| Deck Gear
0 anchors,
0 metres of chain,
Road trailer, Swim Platform, Instrument Covers |
| Fishing
|
|
| Toys
|
| Safety Equipment
Horn, 2 bilge pumps (0 manual / 2 electric) |
| Lying
ELKHART INDIANA |
| Broker's Comments
Register with Boatshed to see 52 extra photos of this Chris Craft Stinger.
These boat details are subject to contract.
Note: Offers on the asking price may be considered. This boat was viewed and photographed by John of Boatshed Lake Michigan. If you had your eye on the Scarab Panther we recently sold, then this Stinger should get your throttle revved up. What hasn’t been done to this awesome machine? Let’s start with the custom 6k paint job and custom windshield. Then we can move to the new carpet and upholstery. But what about the engines you ask. How many hours are on them? Try less than one hour on each after being completely rebuilt from the crankshaft bearings up, and the lower units too including gimble bearings and water pumps. The hull was solidly constructed back when resin and epoxy was cheep. If you tried to buy a new comparable vessel, you would be looking at spending close to 100k and you still wouldn’t get the looks that this boat will bring. If your into rebuilt classics that run like new, then look no further. If you don’t want to be noticed when you pull up to the dock, don’t buy this boat. The owner is selling due to health reasons. There still are some minor details to tend to but thats why you want a classic. To schedule a showing, contact John @ 574-514-3356.
This Chris Craft Stinger has been personally photographed and viewed by John of Boatshed Lake Michigan. Click here for contact details. |
|
